1 Gang Blind/Curtain Module (L+N)

What you need

A PIERRE Wave (Zigbee 3.0, 2.4 GHz) gateway: a PIERRE display and/or gateway. The motor itself is site-supplied.

Warnings:

• Installation must be carried out by a qualified electrician in accordance with local regulations.
• Keep the device out of reach of children.
• Keep the device away from water, damp or hot environments.
• Install the device away from strong signal sources such as microwave ovens that may cause signal interruption resulting in abnormal operation of the device.
• Obstruction by concrete wall or metallic materials may reduce the effective operation range of the device and should be avoided.
• Do NOT attempt to disassemble, repair or modify the device.

The blind module has two switch inputs, S1 (up) and S2 (down), for a wall switch or two push-buttons, so the end user can drive the motor without the app.

Notes:

1. Commands from the app and from the wall switch overwrite each other; the last command applies.
2. The app stays synchronized with the wall switch.

1. Turn off the power supply before carrying out any electrical installation work.
2. Connect wires according to the wiring diagram.
3. Insert the module into the junction box.
4. Turn on the power supply and follow switch module configuration instructions. 

For curtain, roller shutter or blind motor

Three runs. The supply into the module is two conductors at 1.5 mm², line and neutral. Out to the motor: three conductors at 1.5 mm² — up, down and neutral (use a four-core cable if the motor also needs a protective earth). The wall switch or two push-buttons are looped on three conductors at 0.75 mm²: common, S1 for up and S2 for down.

Q1: What should I do if I cannot configure the blind module?

• Check that the module is powered.
• Make sure the PIERRE Wave gateway (PIERRE display and/or gateway) is online.
• Check the wiring against the diagram.

Q2: What can be connected to this blind module?

Curtain, blind and roller shutter motors with separate up and down lines, within the rated load given in the specifications.

Q3: What happens if the Wi-Fi or internet goes down?

The module keeps working locally. You can still drive the motor with the wall switch and control it from the PIERRE display and/or gateway; only remote access from the app is unavailable.

Q4: How do I reset the module?

Toggle the connected wall switch 5 times, power the module off and on 5 times, or press and hold the reset key for about 5 seconds, until the indicator light flashes quickly.

Q5: How should the blinds be wired?

Each motor is wired to its own blind module, which sits in the wall box behind the switch; the switch connects to the module's S1 (up) and S2 (down) inputs. No cable back to a central distribution box is needed.