Configurable I/O
PIERRE Partner - 0–10V Controlled Heat Recovery Unit - (DC Recuperator)
The DC Heat Recovery Unit function in the PIERRE Partner Application is used to configure compatible heat recovery ventilation units with 0–10 V fan speed control . The PIERRE…
PIERRE Partner - Brightness Sensor
The PIERRE system supports integration of BH1750 digital brightness sensors through the controller's I²C interface. The sensor measures ambient light levels and provides real-time…
PIERRE Partner - Generic Modbus
PIERRE Fields This section defines the concept of PIERRE generic modbus, which represent the logical connection between Modbus registers and system-level parameters in the PIERRE…
PIERRE Partner - Humidity and Temperature Sensor (SHT30)
The SHT30 is a combined humidity and temperature sensor connected over the I2C bus. It provides two measured values to the PIERRE system, which can be displayed and used as…
PIERRE Partner - Modbus
The Modbus functionality of the PIERRE system enables compatible third-party devices to be integrated and controlled or monitored through the PIERRE system. Modbus is widely used…
PIERRE Partner - Modbus Transfer Layer
The PIERRE system supports both Modbus RTU (RS485) and Modbus TCP/IP . These interfaces allow Modbus-capable equipment — HVAC controllers, thermostats, inverters, meters and…
PIERRE Partner - RFID Reader
The RFID Reader is a wired access control input connected to a controller. It reads user credentials and passes them to the PIERRE system, where they are matched against the…
PIERRE Partner - Temperature Sensor DS18B20
The PIERRE system supports integration of DS18B20 digital temperature sensors for temperature monitoring, HVAC control, and automation applications. Configuration To add a…
Solution - PID Regulated HC
PID controlled heating and cooling enables continuous valve control using a 0–10 V analog signal . To control such systems, the following components are required: PIERRE…
Solution - RGB Lights
RGB light control drives an RGB LED strip through a PIERRE RGB controler. The driver takes the red, green and blue channels, and the controller sets them, so colour and brightness…