Search
36 results for “switches has:video has:table”
Solution - Gate, Garage Door, Parking Ramp Control
…turns green in the app (or the connected output switches), the controller and the input are fine and the fault is in the device or its cable.
matched in tags, body
Solution - Push Button Control
…ysical wall controls. Standard latching or toggle switches are not used for direct PIERRE PRO input control. When the push button is pressed, it sends the 12 …
matched in tags, body
Fundamental - PIERRE Wave – Setup & Troubleshooting Guide
…l Router Devices include: PIERRE Smart Plugs wall switches or relay modules with permanent L + N power supply compatible permanently powered devices and senso…
matched in body
Intercom Wiring in Condo Buildings
… should be used. Cable lengths, network topology, switches and distribution points must comply with the applicable network and PIERRE design requirements. Pow…
matched in body
PIERRE Display - Berlin 10"
…he Button. Tap in the field Toggle I/O . Toggle - Switches from currently active to opposite state. To confirm your choice tap the button Done . Follow next s…
matched in body
PIERRE Display - Rio 4”
…es the duration after which the I/O automatically switches off once it has been activated by an Automation or another I/O. Modbuses Add a new Modbus interface…
matched in body
PIERRE Partner - Controller Informations
…s connected to the controller, including sensors, switches, and other signal sources. Outputs Configure output channels used for controlling lighting, HVAC eq…
matched in body
PIERRE Partner - Lights
A Light is a controller output that switches a lighting circuit through a relay. The fixture itself does not need to be a smart device – any sta…
matched in body
PIERRE Partner - Motion Sensor
… lights on detected movement, with a timeout that switches them off again. Triggering notifications when movement is detected outside expected hours. Use as a…
matched in body
PIERRE Partner - Push Button
…he Button. Tap in the field Toggle I/O . Toggle - Switches from currently active to opposite state. To confirm your choice tap the button Done . Follow next s…
matched in body
PIERRE Power Supplies - Models
…sic smart home systems. Powering DIN rail network switches. Systems without directly connected electromagnetic locks. 12 VDC / 2A / 24W For larger installatio…
matched in body
PIERRE Thermostat T2
…tat performs the local temperature regulation and switches the connected compatible valve actuator or control input through its own output. This allows the th…
matched in body
PIERRE Wave - Prepare for Wave installation
…dules — wired to the motor and to the mains. Wall switches and dimmers — mains connected at the switch position, with the conductors the model requires. Heati…
matched in body
PIERRE Wave – Wireless System Installation
…nd extend the mesh network. Examples include wall switches, dimmers, relay modules, and blind modules. When planning the installation, distribute routers thro…
matched in body
Smart PIERRE - I/O list
…/Os are grouped by device type — lights, sensors, switches and so on — so a specific device can be located without scrolling the whole system. Search and Filt…
matched in body
Solution - Battery Backup
…ins power failure, the power supply automatically switches to battery operation, ensuring uninterrupted power delivery to connected devices. Applications Batt…
matched in body
Solution - Contact Sensor
…t turns green in the app (or the connected output switches), the controller and the input are fine and the fault is in the device or its cable. When should an…
matched in body
Solution - Contactors
… a 12 V DC control signal to the relay. The relay switches the voltage required by the contactor coil – for example, 230 V AC – while the contactor switches t…
matched in body
Solution - Dimmable Light Control
…n sensor, a brightness reading, or a timeout that switches the light off after a set time. The wall buttons, the automations and the timeouts run inside the c…
matched in body
Solution - Electrical Load Control
…a relay or contactor, and that relay or contactor switches the power supply or the control circuit of the connected device. The Integration Rule If the device…
matched in body
Solution - Electrical Outlet
…tivity Timeout The Timeout function automatically switches the outlet off after a predefined period. This can be used for devices that should only operate for…
matched in body
Solution - Fan/Motor
…n is powered from its own circuit; the relay only switches it. One relay output per fan for a single-speed unit. A multi-speed fan needs one output per speed,…
matched in body
Solution - Gas Boiler
… two ways: • Potential-free contacts: one contact switches winter/summer mode, another starts and stops the heat pump. • Modbus RTU: consult the manufacturer …
matched in body
Solution - Humidity and Temperature Sensors
…gers an output — for example a motion sensor that switches a lamp — add both to the same controller. This gives the fastest response. The sensor comes with a …
matched in body
Solution - HVAC with Blower Speed
… two ways: • Potential-free contacts: one contact switches winter/summer mode, another starts and stops the heat pump. • Modbus RTU: consult the manufacturer …
matched in body
Solution - Irrigation Valve Wiring
…. They need a 24 V AC transformer; the controller switches them through a relay output.
matched in body
Solution - Leak Sensor
…t turns green in the app (or the connected output switches), the controller and the input are fine and the fault is in the device or its cable. When should an…
matched in body
Solution - Modbus Integration
…it carries Direction Value Active On / off state. Switches lights and alarms; reports the state of door / window, tamper and presence inputs; for heating and …
matched in body
Solution - ON/OFF HVAC - Passive Heating Cooling (heating pumps)
…rature with the configured target temperature and switches the corresponding heating or cooling output on or off according to demand. Operating Principle The …
matched in body
Solution - ON/OFF Light control
…n sensor, a brightness reading, or a timeout that switches the light off after a set time. The buttons, the automations and the timeouts run inside the contro…
matched in body
Solution - PIERRE Controllers
…onnect and control various sensors, push buttons, switches, and other controlled devices within a PIERRE installation. The Controller Lite can be used for app…
matched in body
Solution - PIERRE Wave - AC Split Inverter (IR Remote Control)
…nted out of sight of the unit will never work. It switches on and off, but temperature or fan speed do nothing. Why? That is the signature of the wrong model.…
matched in body
Solution - Rain Sensor
…t turns green in the app (or the connected output switches), the controller and the input are fine and the fault is in the device or its cable. When should an…
matched in body
Solution - Sirens
…on has switched it on; when it runs out the siren switches off by itself, even if the alarm condition is still active. The Smart PIERRE app proposes 600 s (10…
matched in body
Solution - Smoke and Fire Sensors
…gers an output — for example a motion sensor that switches a lamp — add both to the same controller. This gives the fastest response. Are the smoke sensors ce…
matched in body
Solutions - Fan Coil control
… two ways: • Potential-free contacts: one contact switches winter/summer mode, another starts and stops the heat pump. • Modbus RTU: consult the manufacturer …
matched in body