Search
45 results for “with has:table has:steps has:diagram type:page section:pierre partner application”
PIERRE Partner - 0–10V Controlled Heat Recovery Unit - (DC Recuperator)
…figure compatible heat recovery ventilation units with 0–10 V fan speed control . The PIERRE system controls the ventilation level through an appropriate …
matched in title, path, body
PIERRE Partner - Alerts
…c events, device states, or automation conditions within the smart home or building system. Alerts help monitor security events, technical failures, acces…
matched in title, path, body
PIERRE Partner - Controller Commissioning
…via Ethernet or 2.4 GHz Wi-Fi 12 VDC power supply with overvoltage protection Connections INPUT 1–16 – Connect sensors, buttons, and other input devices. …
matched in title, path, body
PIERRE Partner - Controller Informations
…ring, and monitoring all PIERRE Wired controllers within a building or project. It provides a centralized overview of controller status, connected devices…
matched in title, path, body
PIERRE Partner - Curtain
…e installation, make sure that a compatible motor with the appropriate wiring is installed for use with the PIERRE system ( L1, L2, N, PE ). Description A…
matched in title, path, body
PIERRE Partner - Doors Control
… each of these columns and when you are satisfied with your choice tap Save button. Choose Sensor Here is a list of Magnet Contact sensors connected to th…
matched in title, path, body
PIERRE Partner - IP Camera Configuration
…e configured, the camera stream will be available within the application. RTSP URL Templates Hikvision Main Stream: rtsp://username:password@IP_ADDRESS:55…
matched in title, path, body
PIERRE Partner - Modbus
…arameters, the wiring and network topology comply with the requirements of the connected devices and the applicable PIERRE wiring documentation. Typical M…
matched in title, path, body
PIERRE Partner - Modbus Transfer Layer
…serial communication over RS485. Used for devices with a two-wire serial port. Modbus TCP/IP — communication over the building network. Used for devices w…
matched in title, path, body
PIERRE Partner - Push Button
…function changes the state of the assigned output with each button press. Example: Current State Button Press New State OFF Press ON ON Press OFF This fun…
matched in title, path, body
PIERRE Partner - Rain Sensor
…pplication. The sensor provides the PIERRE system with information about whether rain is detected. Once configured, the Rain Sensor can be used as a trigg…
matched in title, path, body
PIERRE Partner - RFID Reader
…/embed/vWkDolUOSXo How to Set Up and Connect RFID with a Doorbell https://www.youtube.com/embed/h8Gl3cDI9gU How to Set Up RFID with Fingerprint for Access…
matched in title, path, body
PIERRE Partner - Safety Detectors
…t is designed for integration of 12 VDC detectors with relay outputs. The input can be used for smoke detection, fire alarms, carbon monoxide (CO) detecto…
matched in title, path, body
PIERRE Partner - Services
…can notify staff. Modbus TCP Allows communication with third-party devices over the Modbus TCP protocol, across the local network. Compatible devices exch…
matched in title, path, body
PIERRE Partner - Valves
… Name – The name of the valve used to identify it within the PIERRE system. Image – An optional icon or image used to represent the valve. Role – Defines …
matched in title, path, body
PIERRE Partner - Blinds
…ds, shutters, and similar window covering systems within the PIERRE system. Adding Blinds To add a new blind output: Select the desired Controller. Naviga…
matched in title, path, body
PIERRE Partner - Electrical Outlet
…ing Modes The outlet supports Off, On, Auto, Auto with reset and Timer modes. In auto mode the outlet follows its configured condition, and the Timeout va…
matched in title, path, body
PIERRE Partner - Heat Recovery Unit (Recuperator)
…d Save , the recuperator appears on the dashboard with On , Auto and Off . Fan speed in the app Opening the card shows the Intensity bar. Each level is on…
matched in title, path, body
PIERRE Partner - Motion Sensor
…nge inverted – Triggered when the signal changes, with the signal state interpreted inversely. The selected Signal determines which change in the Motion S…
matched in title, path, body
PIERRE Partner - Fan
…time after the condition ends, then switches off. With 0 the fan follows the condition exactly: on while the condition is true, off when it becomes false.…
matched in title, path, body
PIERRE Partner - Fan Coil
…or in the same building. The form cannot be saved without one. Units with Modbus or a 0–10 V input are added as Modbus devices or as the 0–10 V fan coil t…
matched in title, path, body
PIERRE Partner - Generic Modbus
…ventilation power. Used primarily in HVAC systems with adjustable fan or compressor levels. Value Type: Read-only Description: Provides measurement data f…
matched in title, path, body
PIERRE Partner - Leakage Sensor
…ggered whenever the leakage sensor state changes, with inverted output logic. NC sensors. Use Change when the input represents a continuous state, such as…
matched in title, path, body
PIERRE Partner - Lights
…the light follows the automation rules set on it, with the timeout applied. The rules and the wall buttons run on the controller, so they keep working wit…
matched in title, path, body
PIERRE Partner - Passive Heating and Cooling
…ure sensor, a Modbus thermostat, a PIERRE display with a built-in sensor, or a Wave temperature sensor paired to a display of the same building. The outpu…
matched in title, path, body
PIERRE Partner - Temperature Sensor DS18B20
…the Address should be set to 0. For installations with multiple sensors on the same communication bus, each sensor must be assigned a unique Address value…
matched in title, path, body
PIERRE Partner - Contact Sensor
…ted Triggered whenever the contact state changes, with inverted output logic. Use Change when the input represents a continuous state that should be monit…
matched in title, path, body
PIERRE Partner - Humidity and Temperature Sensor (SHT30)
…m/embed/tQ7NV7yIezs Implementing a Heating System with an SHT Temperature and Humidity Sensor https://www.youtube.com/embed/0jD7j-VpJIs Implementing Heati…
matched in title, path, body
PIERRE Partner - Irrigation
…. Automation Applications Watering on a schedule, with the run time set by Timeout. Suspending watering while a Rain Sensor reports rain, and resuming aft…
matched in title, path, body
PIERRE Partner - Profile
…name and profile picture. Password — changed from within the profile settings. Language — the app interface language, useful when working across regions o…
matched in title, path, body
PIERRE Partner - Siren
…type is used to control indoor and outdoor sirens within the PIERRE system. Sirens can be activated manually, through automations, or by sensor events. Co…
matched in title, path, body
PIERRE Partner - Brightness Sensor
…ness values can be used as conditions or triggers within automation logic. Examples: Lighting Control Turn lights ON when brightness falls below a defined…
matched in title, path, body
PIERRE Application Versions
…acting technical support. Verifying compatibility with system components. Confirming installation of the latest release. Comparing versions across multipl…
matched in title, path, body
PIERRE Partner - Building Management
A Building is the primary logical container within the PIERRE system. All controllers, displays, gateways, devices, inputs, outputs, and automation …
matched in title, path, body
Solution - PID Regulated HC
…nce Between PID and ON/OFF Control ON/OFF Control With ON/OFF control , the valve typically operates in two states: fully open, or fully closed, depending…
matched in path, body
Solution - RGB Lights
…nted out of sight. Description Schemes RGB module with amplifier full Cables Position Wires Diameter Type Comment New From PIERRE to RGB modul 3 0,75 mm² …
matched in path, body
Smart PIERRE - IO Sync (Overview)
…be used intentionally (e.g., to create exceptions within a group), but requires careful planning. How syncing behaves Bidirectional: changes can originate…
matched in path, body
Smart PIERRE - Key Sharing
Key sharing gives someone access without them installing the app. The key is sent as a link or a QR code, and it opens in the recipient's…
matched in path, body
Smart PIERRE - User management
…ed, users can access the application and interact with devices, automations, and other functions according to their assigned permissions. Search and User …
matched in path, body
Smart PIERRE - Valves
…ting, cooling, and other valve-controlled systems within the property. Dashboard Control Valves can be opened or closed directly from the Dashboard with a…
matched in path, body
Smart PIERRE - Fan Coil
…n a gauge, the target temperature, and a fan icon with the current speed. From the card the user can: Turn the unit on or off with the power button. When …
matched in path, body
Smart PIERRE - I/O list
…s and so on — so a specific device can be located without scrolling the whole system. Search and Filter The search bar and the filters narrow the list, wh…
matched in path, body
Smart PIERRE - Irrigation Automation
…tate it had before. Use it for a one-off watering without touching the rules. The Timer tab needs a controller firmware that supports it; the app shows a …
matched in path, body
Smart PIERRE - Lights
…t while the light is on and grey while it is off. With Slide to confirm enabled, the app asks for a swipe before it switches, to prevent accidental taps. …
matched in path, body
Smart PIERRE - Motion Sensor
…by-step below walks through it. Alerts – an alert with the sensor as condition, combined with a time condition using And, sends a push notification when m…
matched in path, body